Asus M2N-SLI - Manual (Page 54)

2-0 Chapter 2: Hardware information
• For a fully configured system, we recommend that you use a power supply
unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version)
and provides a minimum power of 600 W.
• Do not forget to connect the 4-pin ATX +12 V power plug; otherwise, the
system will not boot.
• Use of a PSU with a higher power output is recommended when
configuring a system with more power-consuming devices. The system
may become unstable or may not boot up if the power is inadequate.
10. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that
supports either HD Audio or legacy AC`97 audio standard. Connect one end
of the front panel audio I/O module cable to this connector.
• We recommend that you connect a high-definition front panel audio
module to this connector to avail of the motherboard’s high-definition audio
capability.
• By default, this connector is set to AC97 Audio. If you want to connect a
High Definition front panel audio module to this connector, set the Front
Panel Support Type item in the BIOS to [HD Audio]. See section “4.4.7
Onboard Device Configuration” for details..
M2N-SLI DELUXE Azalia Front Panel Audio Connector
R
M2N-SLI DELUXE
AC ‘97-compliant
pin definition
AAFP
NC
MIC2_L
Line out_R Line out_L
NC
NC
MICPWR
NC AGND
SENSE2_RETU
R
PO
RT
1
L
PO
RT
2
R
PO
RT
2
L
SENSE1_RETU
R
SENSE_SEN
D
PO
RT
1
R
PRESENCE
#
GN
D
Azalia-compliant
pin definition