Asus M2N-SLI - Manual (Page 156)

- Chapter : Software support
Resetting disks to non-RAID
When you install an HDD that has been configured as part of another RAID set,
you may convert this broken RAID HDD to non-RAID mode. All original data,
however, will be lost.
To prevent damage to your system, you cannot select the HDD when
configuring a RAID set through the JMB363 utility.
To reset disks to non-RAID:
1. In the main JMB363 RAID BIOS menu, highlight Revert HDD to non-RAID
using the up/down arrow key then press .
2. Use the space bar to select the HDD that you want to reset to non-RAD.
A selected HDD shows a sign before it.
3. A dialogue box appears to confirm the action. Press to confirm;
otherwise, press .
Saving the settings and exiting setup
When you have finished, highlight Save & Exit Setup using the up/down arrow key
then press to save the current RAID configuration and exit the JMB363
RAID BOS utility.
A dialogue box appears to confirm the action. Press to confirm; otherwise,
press to return to the JMB RAID BIOS menu.