beautypg.com

Jmicron jmb363, Right angle side, 2 chapter 2: hardware information – Asus M2N-SLI User Manual

Page 50

background image

2-2

Chapter 2: Hardware information

4. JMicron JMB363

®

Serial ATA RAID connector (7-pin SATA_RAID1)

This connector is for a Serial ATA signal cable. This connector supports

a Serial ATA hard disk drive that you can configure for RAID through the

onboard Serial ATA RAID controller.

The JMicron JMB363 controller item in the BIOS is set to [IDE] by default,

allowing you to enable the hot-plug function for the external device. Set to

[AHCI] to use the connectors to build a RAID set. See section “4.4.7 Onboard

Device Configuration” for details.

Before creating a RAID set using Serial ATA hard disks, make sure that you

have connected the Serial ATA signal cables and installed Serial ATA hard disk

drives; otherwise, you cannot enter the JMicron

®

JMB363 RAID utility and SATA

BIOS setup during POST.

M2N-SLI DELUXE SATA RAID Connector

SATA_RAID1

G

ND

RS

AT

A_

TX

P1

RS

AT

A_

TX

N1

G

ND

RS

AT

A_

RX

P1

RS

AT

A_

RX

N1

G

ND

R

M2N-SLI DELUXE

Connect the right-angle side

of the SATA signal cable to the

SATA device or you may connect

the right-angle side of the SATA

cable to the onboard SATA port

to avoid placement conflict with

huge graphics cards.

right angle side

This manual is related to the following products: