Asus M2N-SLI - Manual (Page 151)

ASUS M2N-SLI Deluxe -
5.4.3 JMicron ® RAID Configuration
The JMicron ® Serial ATA controller allows you to configure RAID 0 and RAID 1 sets
on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
• At two HDDs, preferably with the same model and capacity.
• A white floppy disk
• Microsoft ® Windows ® OS installation disk (Windows 2000/XP/2003)
• Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the external Serial ATA hard disk drives (HDDs) on your system.
2. Set the Onboard JMB363 Serial -ATA item in the BIOS to [RAID]. See section
“4.4.7 Onboard Devices Configuration” for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
® OS installation. See section
“5.5 Creating a RAID driver disk” for details.
5. Install the JMB363 driver after the Windows ® OS had been installed.
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select Sub-menu F10: Save and Exit
Select Menu
Item Specific Help
Press [Enter] to set
Onboard Device Configuration
IDE Function Setup
Serial-ATA Configuration
USB Configuration
Onboard 1394 Controller [Enabled]
Onboard 1st nVidia LAN [Enabled]
Onboard 2nd nVidia LAN [Enabled]
Onboard LAN Boot ROM [Disabled]
Primary Display Adapter [PCI-E slot]
HD Audio [Auto]
Front Panel Support Type [AC97]
JMicron SATAII Controller [RAID]
Serial Port1 Address [3F8/IRQ4]
Parallel Port Address [378/IRQ7]
Parallel Port Mode [EPP]
x ECP Mode Use DMA 3
Phoenix-Award BIOS CMOS Setup Utility
Advanced