Haltech Platinum PRO PLUG-IN Nissan 350Z Z33 (HT055016) - Manual (Page 4)

ECU Installation
To install your new Platinum Pro Plug-in to your Nissan 350Z / Z33,
please follow the procedures below.
Please Note the following installation photos are based on a Nissan Skyline V35 (JDM)
You will require the following tools
• Screwdrivers Phillips No 2 ,
• Socket set with 10mm socket
1. Locate your factory ECU. This will be located behind the glove compartment
Remove the glove compartment by removing the 6 screws holding it in place
Un clip the glove compartment light and the Airbag wiring from the glove compartment
(Do not disconnect the Air Bag Wiring) Remove glove compartment.
Figure 1 – ECU is located behind the glove compartment
Figure 2 – Left hand footwell showing glove compartment removed
Notes