Ferguson D-990 HX - Manual (Page 5)

1
OK

 
RCU580
Blu-ray
A B C D
+
VIDEO EQ REPEAT A-B
INPUT OPT ZOOM BROWSE
MENU TITLE RETURN SEARCH
STEP SLOW STOP PLAY/PAUSE
AUDIO SUBTITLE
SETUP INFO
MUTE
VOL
POWER EJECT
NEXT
PREV
REV FWD
1 3 2
4 6 5
7 9 8
0/10
ENGLISH
Introduction
Supplied accessories
Remote Control
and
two AAA batteries
Cleaning discs
To clean a disc ,use a micro fibre cleaning
cloth and wipe the disc from the center to
the edge in a straight line.
CAUTION!
Do not use solvents such as benzene,
thinner, commercially available cleaners,
or anti-static sprays intended for discs.
Since the optical unit(laser)of the DVD
system operates at a higher power than
regular DVD or CD players, cleaning CDs
intended for DVD or CD players may
damage the optical unit (laser). Therefore,
refrain from using a cleaning CD.
Safety Information
 Please observe all warnings and
instructions on the equipment and
contained in these operating instructions.
 Please carefully read this user’s manual
before using the device.
 To avoid electric-shock hazards, do not
open the cabinet, refer servicing to
qualified personnel only. If cabinet is
opened warranty will be invalid.
 Please switch off completely the device
during thunder, during abnormal
phenomenon, before cleaning it and in
case it remains out of service for a long
period.
 Do not expose the device under the
sunlight. And keep it away from the heat
source or humid environments. Do not
block ventilation holes of the device so
that air can circulate freely.
 Please place the device in horizontal and
stable conditions, keeping it away from
vibrating.
 If device is moved from warmer place to
a colder one some problem might occur.
Please switch off the device and turn it on
after 1 or 2 hours.
 Keep the device away from flower
vases, tubs, sinks, etc., in order to avoid
damaging the equipment. Do not touch
power supply with wet hands.
 Don’t put any objects on the device.
 Be sure to turn the device off and
disconnect the AC power cord before
cleaning the receiver surface. If the
surface is dirty, wipe clean with a cloth
which has been dipped in a weak soap/
and/water solution and wrung out
thoroughly, and then wipe again with a
dry cloth.
 Do not connect cables while power is
plugged.