Getting started, English, Step 2: setting up the tv – Ferguson D-990 HX User Manual
Page 15: Open the battery compartment, Press power on the dvd player to turn it on
11
30º
OK
Blu-ray
A
B
C
D
+
AUDIO
SUBTITLE
SETUP
INFO
MUTE
VOL
POWER
EJECT
NEXT
REV
FWD
1
3
2
4
6
5
7
9
8
0/10
ENGLISH
Getting Started
Step 1: Inserting batteries into the
Remote Control
A
Open the battery compartment.
B
Insert two batteries type R03 or AAA,
following the indications(+ -) inside the
compartment.
C
Close the cover.
Using the Remote Control to operate
the Player
A
Aim the Remote Control
directly at the remote
sensor (IR) on the front
panel.
B
Do not put any objects
between the Remote
Control and DVD Player
while operating the
DVD Player.
CAUTION!
Remove batteries if they are
exhausted or if the Remote Control is
not being used for a long time.
Do not use old and new or different
types of batteries in combination.
Batteries contain chemical
substances, so they should be disposed
properly.
Step 2: Setting up the TV
IMPORTANT!
Make sure you have completed all the
necessary connections.
A
Press POWER on the DVD player to turn
it on.
B
Turn on the TV and set it to the correct
video-in channel. You should see the DVD
background screen.
Usually these channel are between the
lowest and highest channels and may be
called FRONT, A/V IN, VIDEO. See your TV’s
manual for more details.
Or, you may go to channel 1 on your
TV, then press the Channel down button
repeatedly until you see the Video In
channel.
Or, the TV Remote Control may have
a button or switch that chooses different
video modes.
C
If you are using external equipment,
(eg. audio system or receiver), turn it on
and select the appropriate input source
for the DVD player output. Refer to the
equipment owner’s manual for detail.