elektraLite CP20xt - Manual (Page 2)

In Version 1.12
1. Any fixtures that are enabled will respond to movement of the joystick or control faders. This
gives the operator the option of live performance control even if a macro or chase is running.
Further, when there is a chase running, any channel settings that are adjusted using the faders
or joystick will temporarily override the chase control of those channels. The chase memory will
not be affected.
[Okay what’s that mean in plain English! Well, if you’ve got a chase running
and you want to INSTANTLY grab a fixture (or fixtures) and move it (or them) somewhere else
to light up a different area then you can. No messing around with buttons and faders and
turning off the chase….just go grab them and do it! This is great when someone decides to
grab a microphone and become an impromptu “wedding singer”, if you get my drift!!!!!! Try it
out now because it will save you someday when you least expect it.] .
(I especially want to
thank the person who wanted this!)
In Version 1.13
1. Okay so we missed this one!! Thank you, Mark. Prior to this version you could not delete or
change a submaster. All you could do was “over‐write” it. Version 1.13 takes care of this now
you can edit, delete and “over‐write”.
2. Version 1.13 was the last version of software before the addition of the disk drive.
In Version 1.20
1. Being that the disk drive was a major upgrade the software version jumped to Version 1.2,
missing out 1.14 to 1.19.
2. Version 1.20 added the disk drive options. It was not released to the public because it was still
buggy.
In Version 1.21
1. Version 1.21 was released and had full disk drive support.
In Version 1.23
1. Version 1.23 resolved the issues in midi bank shift controls. V1.22 was a first midi run through
which was not released to the public.
In Version 1.24
1. Our French distributor found that when running the dimmer fixture only one channel could be
designated as the dimmer channel. With a fixture designated as a dimmer all channels need to
be dimmer channels.V1.24 fixed this.(9.2.03).
In Version 1.25
1. This version added over 150 fixtures to the library and set all channels to default as either Snap Before or Crossfade.
All Snap After channels were converted to Snap before.