elektraLite MY 250 - Manual (Page 15)

14
adjusted. In this mode, the device will not react to any control signal.
1. Select
“LADJ” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” if you wish to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] in order to return to the main menu.
- Test function of each channel
With this function you can test each channel on its (correct) function.
1. Select
“tESt” by pressing [UP] button.
2. Press [ENTER], the display shows “T-XX”, “X” stands for the channel number.
3.
The current channel will be tested.
4. Select the desired channel by pressing [UP] button.
5. Press [ENTER] or [EXIT/DN] to exit.
- Main menu 4
1. Press [ENTER] for 3 seconds to enter the main menu (display flashing).
2. Press [UP] to select “TIME”.
- Fixture running time
This function displays the running time of MY 250.
1. Select
“MATI” by pressing [UP] button.
2. Press [ENTER], the display shows “XXXX”, “X“ stands for the number of hours.
3. Press [ENTER] or [EXIT/DN] to exit.
- Lamp running time
This function displays the running time of the lamp.
1. Select
“LATI” by pressing [UP] button.
2. Press [ENTER], the display shows “XXXX”, “X“ stands for the number of hours.
3. Press [ENTER] or [EXIT/DN] to exit.
- Clear fixture time
This function clears the running time of the device.
1. Select
“CLMT” by pressing [UP] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press
[UP] to select “ON” to enable this function or “OFF” if you don’t.
4. Press [ENTER] to confirm.
5. Press [EXIT/DN] to return to the main menu.
- Clear lamp time
This function clears the running time of the lamp. Please clear the lamp time every time you replace the
lamp.