AccuTemp EVOLUTION ELECTRIC STEAMER - Manual (Page 7)

MP4008-0910 EVOLUTION STEAMER OWNERS MANUAL
Page 5
INSTALLATION
CONNECTIONLESS MODELS
This model must be manually filled. A full-size steam table pan or a 1/1 gastronome pan with
a minimum depth of 4” must be installed in the rails underneath the steamer (See Fig. 2)
Failure to install this pan during normal operation can cause damage. It is essential when
draining not to spill or open the drain without this installed. Warranty doesn’t cover any failure
due to this pan not being installed. This pan is not supplied with the steamer and is the
owners responsibility.
WATER LINE CONNECTION - CONNECTED MODELS
The Installer/Owner is responsible for the water connection of this appliance. This appliance is
to be installed to comply with all applicable federal, state, or local plumbing codes. The
National Sanitation Foundation (NSF) requires installation of a check-valve (or other approved
anti-backflow / anti-siphon device) (not provided) in all supply lines in accordance with and as
required by local, state, and national health, sanitation, and plumbing codes.
Fig. 2
CONNECTED MODELS
This model requires a water line connection and a drain connection. These parts are not
supplied with the steamer and are the owners responsibility.
Water Line Connection
Connected Models Only
Fig. 3
Full Size Steam Table Pan
4” Deep
This pan is an optional accessory and must
be supplied by the customer