A.J. Antunes & Co VCT-1000 9210719 - Manual (Page 8)

VERTICAL CONTACT TOASTER
8 P/N 1010930 Rev. C 09/13
1
2
4
5 1 = 1/2"(12.7mm) 2 = 5/8"(15.9mm) 3 = 11/16"(17.5mm)
6 = 7/8"(22.2mm)
THICKNESS THICKNESS
1
2
3
4
6
6
5
4 = 3/4"(19.1mm)
5 = 13/16"(20.6mm) 3
Operating Instructions
OPERATION
1
2
3
4
5
1 = 1/2"(12.7mm)
2 = 5/8"(15.9mm)
4 = 3/4"(19.1mm)
5 =13/16"(20.6mm)
6 = 7/8"(22.2mm)
THICKNESS THICKNESS
1
2
3
4
5
6
6
3 =11/16"(17.5mm)
Figure 3. Bun Thickness Compression Knobs
Figure 2. Toaster Controls
Bun Thickness
Adjustment Controls
Bun Landing
Area Power
Switch
Hi-Limit Reset
Temperature Control
(See Figure 3)
Reset
Button
Protective
Cap
IMPORTANT
Verify that the Release Sheet is installed completely
over the Platen (Figure 1) before proceeding. Failure
to use Release Sheet may cause permanent damage
to the Platen surface that is not covered by warranty.
1. Set the Bun Thickness Compression Knobs
(Figure 3) to the desired settings.
2. Turn the power on.
3. Turn the Temperature Control to 10. Allow the
unit to warm up for 30 minutes before proceeding.
4. Slide buns across the rotating Butter Wheel with
the cut face down and drop buns into toaster
(Figure 2). Cut sides of heel and crown must face
each other.
NOTE: After initial run of 4-6 buns, adjust controls
according to the desired finished product.
5. Toasted product will drop into the Bun Landing
Area (Figure 2).
6. Test at least 4 buns before putting toaster into ser-
vice. Turn Temperature Control to lower setting
for lighter toasting or to higher setting for darker
toasting.
7. Turn the power off when finished toasting and
follow the daily cleaning procedures.
Safety Features
HI-LIMIT RESET BUTTON
A Hi-Limit Control turns off electrical power to the heat-
er if the Platen overheats. To reset this control, allow
10-15 minutes for the unit to cool down, Remove the
Protective Cap, and press the Reset Button located at
the rear of the unit (Figure 2).
If the unit requires continuous resetting, contact your
Authorized Service Agency.
CONVEYOR INTERLOCK SAFETY SWITCH
A Conveyor Interlock Safety Switch is located on top of
the unit under the Heat Shield (Figure 1). The Conveyor
Belt Chains will not rotate unless the Heat Shield is
seated properly in place and activating the Conveyor
Interlock Safety Switch.