Amana VR8205 - Manual (Page 29)

29
BURNERS
WARNING
To prevent personal injury or death, do not
remove any internal compartment covers
or attempt any adjustment. Electrical
components are contained in both
compartments. Contact a qualified service
agent at once if an abnormal flame
appearance should develop.
Periodically during the heating season make a visual check
of the burner flames. Turn the furnace on at the thermostat.
Wait a few minutes, since any dislodged dust will alter the
normal flame appearance. Flames should be stable, quiet,
soft and blue with slightly orange tips. They should not be
yellow. They should extend directly outward from the burner
ports without curling downward, floating or lifting off the
ports.
CLEANING OF BURNERS (QUALIFIED SERVICER
ONLY)
1. Shut off electric power and gas supply to the furnace.
2. Remove the burner box front cover.
3. Remove the burner retention bracket.
4. Remove the burners.
5. Use bottle brush to clean burner insert and inside of
burner.
6. Replace burners and burner retention bracket, inspect
the burner assembly for proper seating of burners in
retention slots.
7. Reinstall the burner box front cover.
Check the burner flames for:
1. Good adjustment
2. Stable, soft and blue
3. Not curling, floating, or lifting off.
Figure 45
Burner Flame
GENERAL INFORMATION
1. When ordering any of the listed functional parts, be sure
to provide the furnace model, manufacturing, and se-
rial numbers with the order.
2. Although only functional parts are shown in the parts
list, all sheet metal parts, doors, etc. may be ordered by
description.
3. Parts are available from your Amana distributor
Gas Valve Blower/Box Gasket
Gas Orifice, Natural Flame Roll-out Switch
Gas Orifice, Propane Auxiliary Limit
Burner Heat Exchanger
Ignitor Door Switch
Flame Sensor Transformer
Gas Manifold Blower Wheel
Ignition Control Blower Housing
Limit Switch Blower Cutoff
Pressure Switch Blower Motor
Pressure Switch Hose Motor Mount Bracket
Induced Draft Blower Capacitor
Collector Box