Alpine INA-W910 - Manual (Page 46)

46
-EN
1
Press SOURCE/ on the unit.
The SOURCE selection screen is displayed.
2
Touch [DISC].
The display shows the DISC mode screen.
Insert a disc with the label side facing up. The unit starts to
play the disc.
• The operation screen changes to the visual screen in the DVD or
Video CD mode for 5 seconds after an operation has been performed.
Touch the display panel to display the operation screen again.
• The display mode can be changed by touching [WIDE].
For operation, see “Switching Display Modes” on page 55.
Inserting/Ejecting a Disc
Refer to “Inserting/Ejecting a Disc” (page 18).
• The reverse side of a double-sided DVD will not be played
automatically.
Remove the disc, turn it over , and reinsert it.
• DO NOT insert discs containing maps for the navigation system.
Doing so could result in damage.
• Refer also to “DVD Setup” (pages 55-60).
• Be sure the remote input lead is connected to the remote output lead
of this unit when a DVD changer or DVD player is connected. If not
correctly connected, touch operation cannot be performed.
• “Can’t Downmix” is displayed when a Downmix (multi-channel
signals are mixed into 2ch) prohibited section of a DVD-Audio disc is
played. In this case, only the Lch/Rch recorded on the disc is output
as sound. (The sound of Centre speaker, L-surround speaker,
R-surround speaker , and Subwoofer is not output.)
On DVDs and Video CDs with playback control (PBC), menu screens
may appear automatically. If this happens, perform the operation
described below to start playback.
• To play back a DVD-Audio disc, set “VCAP” in “Setting the DVD-
Audio Playback Mode” (page 59).
Direct Menu Operations
Touch the DVD menu directly.
Menu Operations
1 Touch any area on DVD mode screen to display the operation
keys.
2 Touch [Key].
The menu operation mode will be displayed.
3 Select a desired menu item by touching [ ], [ ], [ ] or [ ].
4 Touch [Enter] to confirm the selected item.
Numeric Keypad Input Operations
1 Touch any area on DVD mode screen to display the operation
keys.
2 Touch [Key].
The menu operation mode appears.
3 Touch [Key] again.
The numeric keypad input mode screen appears.
4 Touch a desired number.
5 Touch [Enter] on the numeric keypad mode screen to confirm
your selection.
Numeric Keypad Input Operations
When PBC is turned OFF, the menu screen is not displayed. Turn
it ON to display the screen (See “Setting the Video CD Play
Mode” on page 60).
1 Touch [P1/2] in the Video CD mode to change to the function
guide.
2 Touch [10KEY].
The numeric keypad is displayed.
3 Touch and input a desired number.
4 Touch [Enter] to confirm.
If a menu screen appears
• Some operations cannot be performed depending on the disc.
The numeric
keypad input
screen closes
when the area is
touched while
displayed.
Touch [ ] to close the numeric
keypad input screen.