Allied Telesis OmniConnect MultiModem - Manual (Page 24)

Installation
16
The Modem Parameter Verification screen verifies the configuration of the
modems, the ISP information and the DNS information. Each of these
parameters are checked in tern for each modem that is enabled. If there is a
failure, an 'x' is displayed next to the failing item, and if the configuration is
correct, a check mark is displayed. As shown in the example above, Modem 1’s
configuration failed, while Modem 2 and Modem 3 are correctly configured and
their ISP information and DNS information are also correct.
Modem Configuration verifies that the modem is correctly configured, is turned
on and connected to a proper analog phone line. If any of these are not true,
Modem Configuration returns a failure.
Lastly, DNS Configuration verifies the DNS server address that is entered in the
DNS screen. If this is incorrect, this test returns a failure.
ISP Configuration checks to see if the ISP information (login, password and
phone number) are correct and a login is possible. If any of these are not correct,
this test returns a failure.
If there were any failures, press Next to go to the next screen, then press the Back
button to reenter the configuration and make corrections.
When the test returns satisfactory results, this concludes the setup process for a
simple installation. Press the Next button to go to the next screen.