Allied Telesis SNMPc Enterprise Manager - Manual (Page 7)

3
Getting Started
System Requirements
Before installing any SNMPc 5.0 Enterprise components you must verify
that the following hardware and software components are installed and
properly configured:
•
IBM PC/AT compatible Pentium Pro 166MHz with 64MB memory.
•
At least 100MB free hard disk space.
•
CD-ROM Disk Drive.
•
Minimum 800X600 Color Adapter and Monitor
•
Mouse.
•
Microsoft Windows NT 4.0 or greater for Basic System/Poller
•
Microsoft Windows 95, 98, or NT40 for Remote Console
•
Microsoft TCP/IP Transport Protocol.
•
Microsoft WinSock2.
•
Internet Explorer Version 4.0
•
Dial-up or LAN network interface.
In addition, you must make sure that the following software is not running
on your computer:
•
Any SNMP network management software (e.g., HP OpenView,
SNMPc 4.0). Agent software is OK.
•
Any software that receives SNMP traps on the SNMP UDP Trap Port.
For example, the Microsoft SNMP Agent Service can be configured to
receive SNMP Traps.
Installing Notify!Connect
SNMPc 5.0 Enterprise includes a copy of Notify!Connect from ExMachina
Corporation. SNMPc 5.0 Enterprise can use Notify!Connect to send a
message to your pager when an important event occurs. If you plan to use
this feature then you should install Notify!Connect before installing SNMPc
5.0 Enterprise.