Auto Page RF-350 User Manual
Page 6
6
Note: If more than 4 transmitters are programmed, the system will only
keep the last 4 transmitters and delete the others.
ALARM FEATURE “A” PROGRAMMING:
1. Turn the Ignition 'switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 3 times and hold in on the 3
rd
push. When a long
chirp is heard, release the valet switch. You are now in the Alarm
feature ‘I’ programming mode.
3. Press the transmitter button corresponding to the feature you want to
program.
a. The factory default settings is always [1] LED flash, [1] chirp.
4. Depress the transmitter button again to change the feature. Simply
keep pressing the transmitter button again until the module advances
to your desired setting.
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long
chirps will confirm exit.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulses
Three Chirps
/
LED three
pulses
Four Chirps /
LED four
pulses
1
Active arming
Passive arming
without passive
door locking
Passive
arming with
passive door
locking.
2
Automatic Rearm off
Automatic Rearm
on
3
Instant Door Ajar error
chirp
45 seconds delay
Door Ajar error
chirp.
4
Siren Confirmation
chirp on only
All Confirmation
chirps On
Horn
Confirmation
chirp on only
All
Confirmation
chirps off
5
+
H2/2 White wire=
Dome Light Output
H2/2 White wire=
3
rd
Channel
Momentary
H2/2 White =
3
rd
channel
Latched
6
+
Lock/Arm &
Unlock/Disarm
Confirmation Chirps
Lock/Arm
Confirmation
Chirp Only
7.
+
ALARM with
Keyless Entry
Keyless Entry
ONLY
8.
+
Car Jacking feature
Off
Car Jacking
feature On