Allied Telesis AT-GS905 - Manual (Page 27)

AT-GS905 Gigabit Ethernet Switch Installation Guide
27
Wall- Mounting the Switch
The AT-GS905 switch can be used on a desktop or mounted onto a wall.
To use the switch on a desktop, refer to Using the Switch on a Desktop
on page 26.
To mount an AT-GS905 switch onto a wall, perform the following
procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. Select a wall location for the switch.
3. Mark two hole locations (3-3/8 inches apart) on the wall.
4. At the two marked locations for the holes, pre-drill for the drywall
anchors (provided) and drive the screws (provided) through the
holes.
5. Align the switch horizontally, as illustrated in Figure 6.
Figure 6 Aligning an AT-GS905 Switch For Wallmount Installation
A T-G S905 10/100 /1000 Ba se-T Gig abit E therne t Sw itch PO WER
1 2 3 4 5 100M 1000M LNK/ACTFDX
2
3
4
1
5