Allied Telesis AT-FS708 - Manual (Page 29)

AT-FS708 Fast Ethernet Switch Installation Guide
29
Wall-Mounting the Switch
The switch can be mounted horizontally on a wall using the mounting
brackets that come with the unit. The wall-mounting screws, plastic
anchors, and other materials necessary to mount the switch on a wall are
not provided.
To mount an AT-FS708 switch onto a wall, perform the following
procedure:
1. Remove all equipment from the package and store the packaging
material in a safe place.
2. If attached, remove the rubber feet, data cables, and power cord from
the switch.
3. Select a wall location for the switch.
4. Mark two hole locations on the wall.
5. At the marked locations for the holes, pre-drill for the drywall anchors
and drive the screws through the holes.
6. Align the switch horizontally, as illustrated in Figure 8.
Figure 8. Aligning an AT-FS708 for Wallmount Installation
988
AT-FS70
8
8 P ort 1 0/1 00 M bps Fa st E thern et S witc h
POW ER
LIN K/A CT 100 M
FDX 1 2 3 4 5 6 7 8
1
2
3
4
6
7
8
5