Allied Telesis AT-FS708 - Manual (Page 28)

Chapter 2: Installation
28
Installing the Switch in a Rack
Perform the following procedure to install the switch in a standard 19-inch
rack.
1. If attached, remove the rubber feet, data cables, and power cord from
the switch.
2. Attach the two mounting brackets (provided) to the sides of the switch
using the bracketmounting screws (provided), as shown in Figure 6.
Figure 6. Attaching Brackets for Rackmounting
3. Mount the switch in a 19-inch rack using rackmounting screws (not
provided), as shown in Figure 7.
Figure 7. Rackmounting the Switch
The switch is now ready for cabling and powering up.
993
AT- FS708 8 Port 10/100 M
bps Fa st Ethernet S
witch POWE R LINK /ACT
100M
FDX
1 2 3 4 5 6 7 8
1
2
3
4
6
7
8
5
994
AT- FS7 08 8 Port 10/100 M bps Fa st Eth ernet S witch POWE R LINK/A CT
100M
FDX
1 2 3 4 5 6 7 8
1
2
3
4
6
7
8
5