Allied Telesis AlliedView-EMS 3.10 AMIGO - Manual (Page 24)

4.1.6.1 Setting MIB-Files Tab
In the Setting MIB-Files tab, you can specify which MIB files AMIGO uses to
draw the MIB tree. To add a MIB file, enter a file name in the MIB-File name
textbox then click Add or select a MIB file using the Browse button. To remove
a MIB file, select a file from the list then click Delete.
Auto Add
Using the "Auto Add" button, you can automatically add the MIB files
which are required to manage the target device. When you click "Auto
Add", MIB files which are needed by the target hosts specified in the
"Setting target devices" tab are added to the MIB files list.
You can automatically add MIB files only if the target device is supported
by AlliedView-EMS.
Select MIB-Files tab
4.1.6.2 Setting Target Devices Tab
In the "Setting target devices" tab, you can add or remove a target device
to/from which MIB values are set or retrieved. You can also configure the SNMP
connection properties of a target device.
AlliedView™-EMS 3.10 AMIGO USERS GUIDE Page 24 of 43