Allied Telesis AT-8000S - Manual (Page 11)

Product Description
Page 11
AT-8000S/24 Front Panel
The following figure illustrates the AT-8000S/24 front panel.
Figure 3: AT-8000S/24 Front Panel
The AT-8000S/24 front panel is configured as follows:
• 24 10/100Mbps Ports — RJ-45 ports designated as 10/100Base-T. The RJ-45 ports are designated as ports
Ports 1 - 24.
• 2 10/100/1000Base-T Copper Ports — There are two copper 10/100/100Base-T ports designated on the
switch as ports 25R and 26R. These ports are paired with the two SFP slots designated on the switch as
ports 25 and 26. Together these four ports form the Combo ports shown in
Figure 3 ..
• 2 SFP Ports— There are two SFP slots which support either a 100Base-FX or a 1000Base-X (fiber)
connection and are designated on the switch as ports 25 and 26. This SFP slot is paired with the two 10/100/
1000Base-T copper ports which is designated on the switch as port 25R and 26R. Together these four ports
form the Combo ports shown in
Figure 3 .
• DB-9 Console port — An asynchronous serial console port supporting the RS-232 electrical specification.
The port is used to connect the device to the console managing the device.
• Reset Button — Button to reset the device.
• Mode Button — Selects the port LED indications.
AT-8000S/24 Back Panel
The following figure illustrates the AT-8000S/24 back panel.
Figure 4: AT-8000S/24 Back Panel
The AT-8000S/24 back panel is configured as follows:
• Power Connector — AC power supply interface.
• 2 Stacking Ports — Two RJ-45 ports device stacking.