Allied Telesis AT-AR256E v3 - Manual (Page 13)

AT-AR256E v3 4 Ports ADSL2/2+ Router Quick Setup Guide 13
Configuring TCP/IP Settings
After connecting the device, you need to set the TCP/IP properties in your computer.
Note: These instructions apply to connections made using the Ethernet port.
To set the TCP/IP properties:
1. Select Start > Run. This opens the Run dialog box.
2. Enter control ncpa.cpl then click OK. This opens the Network Connections in your computer.
3. Right-click on LAN then select Properties. This opens the Local Area Connection Properties
dialog box.
4. Select Internet Protocol (TCP/IP) then click Properties. This opens the Internet Protocol
(TCP/IP) dialog box.
5. Select Obtain an IP address automatically.
6. Click OK to close the Internet Protocol (TCP/IP) dialog box.
7. Click OK to close the Local Area Connection Properties dialog box.
Configuring Internet Properties
To set the Internet Properties:
1. Select Start > Run. This opens the Run dialog box.
2. Enter control inetcpl.cpl then click OK. This opens the Internet Properties dialog box.
3. Click the Connections tab.
4. In the Dial-up and Virtual Private Network settings pane, select Never dial a connection.
5. Click OK to close the Internet Properties dialog box.
Removing Temporary Internet Files
To remove Temporary Internet Files:
1. Select Start > Run. This opens the Run dialog box.
2. Enter control then click OK. This opens the Control Panel.
3. Double-click Internet Options. This opens the Internet Options dialog box.
4. In the Temporary Internet Files pane, click Delete Cookies.
5. Click Delete Files.
Click OK to close the Internet Properties dialog box.