Audio Authority Cat 5 HDMI Extender HDP-11 - Manual (Page 7)

6 7
3.2 CONNECTING THE HARDWARE
1. Connect the HDMI source device’s output to the HDMI INPUT
connector of the 1381T Transmitter, using a short, high quality, HDMI
cable.
2. Connect a correctly terminated and tested Cat 5 cable to the Cat 5
Output A connector of the Transmitter. Connect a second Cat 5 cable
to the Cat 5 Output B. Mark the cables at both ends so that you do
not inadvertently swap them. Do not connect the AC adapter until the
Cat 5 cables are correctly connected to both the transmitter and the
receiver.
Again, always test the HDMI source on the intended display with a
known good HDMI cable before using the HDP-11. This precaution
insures that the source can be (and is) set to a resolution that is
compatible with the display, and that both are functioning correctly
together.
3. At the remote location, connect the appropriate Cat 5 cables to the Cat
5 Input A and B connectors of the 1381R Receiver. Be careful not to
interchange the A and B cables. Cable A must be connected to both
the transmitter and the receiver and Cable B must be connected to the
B inputs on both devices in most cases, depending on the source.
4. Connect the HDMI OUTPUT of the 1381R to the HDMI input of the
video display or other device, using the appropriate cable.
5. Connect the supplied AC adapters first to the 1381T and 1381R and
then to the AC outlets.
6. Turn on the source device and video display. The source video signal
should appear on the display. If not, consult the Troubleshooting Guide
in this manual.