Samsung MX-F630B-ZA - Manual (Page 4)

4
English English
4
English
5
Precautions
• Ensure that the AC power in your house matches the
requirements listed on the identification sticker located on
the back of your product.
• Do not place the product on amplifiers or other equipment
which may become hot. Make sure the ventilation slots are
not covered.
• Do not stack anything on top of the product.
• Before moving the product, ensure the Disc Insert Hole is
empty.
• To turn off the product completely, disconnect the AC plug
from the wall outlet. Disconnect the AC plug from the wall
outlet if you will leave the device unused for a long period
of time.
• During thunderstorms, disconnect the AC plug from the wall
outlet. Voltage peaks due to lightning could damage the
product.
• Do not expose the product to direct sunlight or other heat
sources. This could cause the product to overheat and
malfunction.
• Protect the product from moisture and excess heat and
equipment creating strong magnetic or electric fields (i.e.
speakers.).
• Disconnect the power cable from the AC supply if the
product malfunctions.
• This product is for personal use only. It is not intended for
industrial use.
• Condensation may occur if your product or a disc has been
stored in cold temperatures. If transporting the product
during the winter, wait approximately 2 hours until the
product has reached room temperature before using.
• The batteries used with this product contain chemicals
that are harmful to the environment. Do not dispose of
batteries in the general household trash.
• Maintain an open space of approximately 6 inches (15 cm)
on the sides and rear of the system, for ventilation purposes.
• Place the loudspeakers at a reasonable distance on either
side of the system to ensure good stereo sound.
• Direct the loudspeakers towards the listening area.
Disc Types And Disc Format
This product does not support Secure (DRM) Media files.
CD-R Discs
• Some CD-R discs may not be playable depending on
the disc recording device (CD-Recorder or PC) and the
condition of the disc.
• Use 650MB/74 minute CD-R discs.
Do not use CD-R discs over 700MB/80 minutes as they
may not be played back.
• Some CD-RW (Rewritable) media, may not be playable.
• Only CD-Rs that are properly "closed" can be fully played. If
the session is closed but the disc is left open, you may not
be able to fully play the disc.
CD-R MP3 Discs
• Only CD-R discs with MP3 files in ISO 9660 or Joliet format
can be played.
• MP3 file names should contain no blank spaces or special
characters (. / = +).
• Use discs recorded with a compression/decompression
data rate greater than 128Kbps.
• Only files with the ".mp3" and ".MP3" extensions can be
played.
• Only consecutively written multisession discs can be
played. If there is a blank segment in a Multisession disc,
the disc can be played only up to the blank segment.
• If a disc is not closed, it will take longer to begin playback
and not all of the recorded files may be played.
• For files encoded in Variable Bitrate (VBR) format, i.e. files
encoded in both low Bitrate and high Bitrate (e.g., 32Kbps
~ 320Kbps), the sound may skip during playback.
• A maximum of 999 tracks can be played per CD.
• Supported Audio Formats:WMA 56~128kbps Bitrate.
Cautions on Handling and Storing Discs
Small scratches on the disc may reduce sound and picture
quality or cause skipping.
Be especially careful not to scratch discs when handling
them.
Holding discs
• Do not touch the playback side of the disc.
• Hold the disc by the edges so that fingerprints will not get
on the surface.
• Do not stick paper or tape on the disc.
Disc Storage
• Do not keep in direct sunlight.
• Keep in a cool, ventilated area.
• Keep in a clean, protective jacket.
Store vertically.
• Do not allow the discs to become contaminated with dirt.
• Do not use cracked or scratched discs.
Handling and Storing Discs
If you get fingerprints or dirt on a disc, clean it with a mild
detergent diluted in water and wipe with a soft cloth.
• When cleaning, wipe gently from the inside to the outside of
the disc
• Condensation may form if warm air comes into contact
with cold parts inside the product. When condensation
forms inside the product, it may not operate correctly. If this
occurs, remove the disc and let the product stand for 1 or 2
hours with the power on.
MX-F630B-F730B-ZA-ENG-0201-EQ.indd 4 2013-2-19 9:33:05