Samsung HT-D4500-ZA - Manual (Page 24)

24
English
Connections
Wireless Network
You can connect the home theater to your network through a wireless IP sharer (router).
Connect the wireless LAN adapter (sold separately) to the Wireless LAN Adapter jack on the rear
panel of the product.
Set the network options. (See page 33)
NOTE
This product is compatible with Samsung's Wireless LAN Adapter only. (Model name: WIS09ABGN).
- The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer to
purchasing.
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable
operation of the wireless network.)
Wireless LAN, by its nature, may cause interference, depending on the network environment (router
performance, distance, obstacles, interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
The home theater supports the following security protocols only:
Authentication Mode : WEP, WPAPSK, WPA2PSK
Encryption Type : WEP, AES
For the AllShare function, a PC must be connected in the network as shown in the fi gure.
Connecting the FM Antenna
Connect the FM antenna supplied to the FM
ANTENNA Jack.
Slowly move the antenna wire around until you fi nd
a location where reception is good, then fasten it to
a wall or other rigid surface.
NOTE
This product does not receive AM broadcasts.
1.
2.
✎





1)
2)

1.
2.
✎
 HDMI OUT
FM ANT
HDMI OUT
FM Antenna (supplied)
WIRELESS LAN
5V 350mA
LAN
COMPONENT OUT
VIDEO OUT AUX IN
LAN
COMPONENT OUT
VIDEO OUT AUX IN
Wireless IP sharer
Wireless LAN Adapter
(not supplied)
Broadband
service
Networking with PC for
AllShare function
(See page 62)
PC
HT-D4500_XAA_1223.indd 24 HT-D4500_XAA_1223.indd 24 2011-12-23 3:39:46 2011-12-23 3:39:46