Samsung RF23HSESBSR-AA - Manual (Page 12)

3. Pull and remove the hinge lever ( 5 ).
Remove the ground screw ( 6 ) attached
to the upper left door hinges with a philips
screwdriver (+).
Remove the upper left and right door hinges
( 7 ).
(2)
(7)
(6)
4. Open the door (more than 90°), lift from the
middle hinge, and remove the door.
- Due to its design features, you can only
disassemble and re-assemble the door when
the door is open.
(The holes in the Door Shaft and the Door
Middle Hinge are deliberately tilted at specific
angles so that it is difficult to disassemble and
re-assemble with the door closed.)
CAUTION
Place the door, inside facing up, on a non-
scratching surface.
Auto Closing Hinge
Check the direction
Door Middle Hinge
- If the Auto Closing Hinge is aligned vertically as
shown in the figure, align it so that it is parallel
using the Door Middle Hinge.
(Refer to Step 5 below for the disassembly of
the Door Middle Hinge)
CAUTION
Do not use a flat head screwdriver to align the
Auto close Hinge. It may get damaged.
Use the Door Middle Hinge instead.
5. Remove the screw ( 8 ) attached to the
lower left and right door hinges with a philips
screwdriver (+).
Remove the 2 hex head bolts ( 9 ) attached
to the lower left and right door hinges with an
allen wrench (5 mm).
Remove the lower left and right door hinges
( 10 ).
Allen wrench
(10)
(8)
(9)
English - 12