Asus EVOLUTION P5E64 WS - Manual (Page 58)

2-32 Chapter 2: Hardware information
9. CPU, chassis, and power fan connectors
(4-pin CPU_FAN, 3-pin CHA_FAN1-4, 3-pin PWR_FAN)
The fan connectors support cooling fans of 350 mA~2000 mA (24 W max.)
or a total of 1 A~7 A (84 W max.) at +12V. Connect the fan cables to the fan
connectors on the motherboard, making sure that the black wire of each
cable matches the ground pin of the connector.
Do not forget to connect the fan cables to the fan connectors. Insufficient air
flow inside the system may damage the motherboard components. These are
not jumpers! Do not place jumper caps on the fan connectors!
Only the CPU-FAN and CHA-FAN 1-2 connectors support the ASUS Q-FAN 2
feature.
P5E64 WS EVOLUTION
®
P5E64 WS Evolution Fan connectors
CPU_FAN CHA_FAN1
CHA_FAN2
PWR_FAN
GN
D
CPU F
AN PW
R
CPU
FA
N IN
CPU F
AN PW
M
GN
D
Rotation
+12
V
GND
Rotation
+12V
GN
D
Rotation +12V
GN
D
Rotation +12V
CHA_FAN3
GND
Rotation
+12V
CHA_FAN4
10. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
P5E64 WS EVOLUTION
®
P5E64 WS Evolution Chassis intrusion connector
CHASSIS
+5VSB_M
B
Chassis Signal
GN
D
(Default)