Asus Motherboard A8N-SLI SE - Manual (Page 81)

ASUS A8N-SLI SE 4-23
F1:Help ↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →←: Select Menu Enter: Select Sub-menu F10: Save and Exit
Select Menu
Item Specific Help
Select Yes if you are
using a Plug and Play
capable operating system.
Select No if you need the
BIOS to configure non-boot
devices.
Frequency/Voltage control
Plug & Play O/S [No]
Init Display First [PCI]
Resources Controlled By [Auto]
x IRQ Resources
Phoenix-Award BIOS CMOS Setup Utility
Advanced
4.4.2 PCI PnP
Plug & Play O/S [No]
When set to [No], the BIOS configures all the devices in the system.
When set to [Yes] and if you install a Plug and Play operating system, the
operating system configures the Plug and Play devices not required for
boot. Configuration options: [No] [Yes]
Resources Controlled By [Auto]
When set to [Auto], the BIOS automatically configures all the boot and Plug
and Play compatible devices. Set to [Manual] if you want to assign the IRQ
DMA and memory base address fields.
Configuration options: [Auto] [Manual]
Init Display First [PCI]
Allows you to select which graphics controller to use as the primary boot
device. Configuration options: [PCI] [PCI-E]
When the item Resources Controlled By is set to [Auto], the item IRQ
Resources is grayed out and not user-configurable. Refer to the section
“IRQ Resources” for information on how to enable this item.