Asante Technologies 2072 - Manual (Page 14)

Page 13
Cable Connections to Other Devices
∆
If you are managing only one hub, set DIP
Switch 1
DOWN (END).
5 Set DIP Switch 2 DOWN (SETUP) on all hubs.
6 If you change a DIP switch setting, you must reset the
hub or NMM. Press the
Reset button.
7 To connect an AsantéView Management Station to a
hub, follow the instructions in "Connecting a Manage-
ment Station to the Hub" on page 13.
For a summary of DIP switch settings, see Figure 6 on
page 15 and Figure 7 on page 16.
Figure 4 Connecting hubs in an Out-of-Band daisy-chain
Connecting a
Management Station to
the Hub
To connect an AsantéView Management Station to the hub:
1 Connect one end of the AMS Link Extender to a PC or
Macintosh and the other end to an AMS Link connec-
tor port. Figure 5 shows how to make this connec-
tion.
DIP Switch 1
DOWN (END)
on end hub only
Hub 1
Hub 2
DIP Switch 1 UP
(THROUGH)
on all other hubs
1 2
1 2
1 2
DIP Switch 2 DOWN
(SETUP) on all hubs
End Hub
Mac or PC
AMS Link
Extender
RJ45
to Mac or PC
AsantéView
Management
Station (AMS)