Samsung RF30HDEDTSR-AA - Manual (Page 26)

English - 26
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it difficult to
remove them.
To remove the ice bucket, lift up the bottom, and
then pull out. To put the bucket back in, push the
bucket straight back until you hear a click.
If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
CAUTION
• The inside of the ice bucket stays cold when it
is operating.
Do not reach deep inside the ice bucket.
• Use only the ice maker provided with the
refrigerator. The water supply to this refrigerator
must only be installed/connected by a suitably
qualified person.
Connect to a potable water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
Going on vacation...
If you are going on a long vacation or business trip
and won’t use the water or ice dispensers for a
long time:
• Close the water valve. Otherwise, water
leakage may occur.
• Remove all food.
• Unplug the refrigerator.
• Wipe excess moisture from inside and leave
the doors open. Otherwise, odor and mold may
develop.
Ice Maker Do’s and Don’ts
• Do not put your fingers, hands, or any other
unsuitable objects in the chute or ice-maker
bucket.
- It may result in personal injury or material
damage.
• Never put your finger or any other objects in the
dispenser opening.
- It may cause injury.
• Do not try to disassemble the ice maker.
• Do not wash or spray the ice bucket with water
while it is in the refrigerator.
Remove it to clean it.
CAUTION
When you insert the Ice maker tray, be sure that
the tray is well centered at the entrance.
Otherwise, the tray may get stuck.
Water clouding phenomenon
All water provided to the refrigerator flows
through the core filter which is an alkaline
water filter.
In the filtering process, the pressure of
the water that has flowed out of the filter
is increased, and the water becomes
saturated with oxygen and nitrogen.
When this water flows out into the air, the
pressure plummets and the oxygen and
nitrogen get supersaturated, which results
in gas bubbles.
The water may temporarily look misty or
cloudy due to these oxygen bubbles.
After a few seconds, the water will look
clear.
DA68-03028A-02.indb 26 14. 6. 5. �� 1:24