Samsung LTN1765X-XAC - Manual (Page 9)

1.4
Y O U R N E W T V
Remote Control
You can use the remote control up to about 23 feet from the TV
When using the remote, always point it directly at the TV.
Power (Page 3.1)
Turns the TV on and off.
TV/VIDEO (Page 3.11)
Press to display all of the
available video sources.
P.STD (Page 3.8)
Adjust the TV picture by
selecting one of the preset
factory settings (or select your
personal, customized picture
settings).
PC (Page 5.1)
Press to switch to the PC mode.
MENU
Displays the main on-screen
menu.
-
VOL / VOL
+
Press to increase or decrease
the volume. (Also used to
make selections on the
on-screen menus.)
CH ▲ / CH ▼
(Channel Up/Down)
Press CH▲ or CH▼ to change
channels. (Also used to
highlight selections on the
on-screen menus.)
MUTE (Page 3.6)
Press to temporarily cut off
the sound.
NUMBER BUTTONS
Press to select channels
directly on the TV.
+100 (Page 3.5)
Press to select channels over 100.
For example, to select channel
121, press “+100,” then press
“2” and “1.”
SLEEP (Page 4.6)
Press to select a preset time
interval for automatic shutoff.
ASPECT (Page 4.3)
Press to change the screen size.
MTS (Page 4.4)
(Multichannel Television Stereo)
Press to choose stereo,
mono or Separate Audio
Program (SAP broadcast).
CAPTION (Page 4.7)
Press to set caption on/off.
V.CHIP (Page 4.10~4.14)
Press to set up and activate
the parental locks.
STILL (Page 4.3)
Press to stop the action during a
particular scene. Press again to
resume normal video.
S.STD (Page 3.10)
Adjust the TV sound by selecting
one of the preset factory settings
(or select your personal,
customized sound settings).
DISPLAY (Page 3.1)
Press to display the current
channel and the audio-video
settings.
EXIT
Press the menu to exit.
When the PIP is active, press
the Exit button to turn PIP off.
PRE-CH (Page 3.5)
Tunes to the previous channel.
AUTO (Page 5.8)
Press to self-adjust to the
incoming video signal.
The values of fine, coarse and
position are adjusted
automatically.
(It does work only in PC mode.)
It works only in PC full- screen
mode. It does not work when the
PIP is active.
CH.SCAN
It displays the memorized
channels in order, starting from
the currently selected channel.
ADD/ERASE (Page 3.5)
Press to add or erase channels
in the TV’s memory.
It works only in PC full- screen
mode. It does not work when the
PIP is active.
PIP CONTROLS
(Page 4.8~4.9)
LOCATE
Press to move the PIP window
to any of the four corners of the
TV screen.
SIZE
Press to make the PIP window
double, large or small.
PIP ON
Activates picture in picture
window directly in PC mode.
It is available in PC mode only
It does not work on other screen.
Push PIP ON button to switch
the PIP source:
PC + ant -> PC + Video ->
PC + S-Video.
If the PIP is active, the sound
of PC mode is switched to the
sound of the PIP screen.
To turn PIP off, press the
Exit button.
05-CHAPTER 1_en 6/9/03 1:29 PM Page 4