Samsung HW-HM60-ZA - Manual (Page 16)

FUNCTIONS
16
+ Bluetooth POWER on (Bluetooth
POWER)
When the Bluetooth Power On function is on and
the SoundStand is turned off, if a previously paired
Bluetooth device tries to pair with the SoundStand,
the SoundStand turns on automatically.
1. Press the Bluetooth POWER button on the
remote control.
2. Bluetooth POWER on appears on the
SoundStand's display.
● Available only if the SoundStand is listed
among the Bluetooth device’s paired
devices. (The Bluetooth device and the
SoundStand must have been previously
paired at least once.)
● SoundStand will appear in the Bluetooth
device’s searched devices list only when
the SoundStand is displaying [BT READY].
● In the TV SoundConnect mode, the
SoundStand cannot be paired to another
Bluetooth device.
● If the SoundStand is connected to a TV
through TV SoundConnect, and you turn
the SoundStand off by turning off the TV,
the Bluetooth Power function will not turn
the SoundStand on.
+ To disconnect the Bluetooth
device from the SoundStand
You can disconnect the Bluetooth device from the
SoundStand. For instructions, see the Bluetooth
device's user manual.
● The SoundStand will be disconnected.
● When the SoundStand is disconnected from the
Bluetooth device, the SoundStand will display
BT DISCONNECTED on the front display.
+ To disconnect the SoundStand
from the Bluetooth device
Press the SOURCE button on the remote control or
the ( ) button on the product's top panel to
switch from BT to another mode or turn off the
SoundStand.
● The connected Bluetooth device will wait a
certain amount of time for a response from the
SoundStand before terminating the connection.
(Disconnection time may differ, depending on
the Bluetooth device)
● In Bluetooth connection mode, the
Bluetooth connection will be lost if the
distance between the SoundStand and
the Bluetooth device exceeds 16.25 ft.
(5m).
● The SoundStand automatically turns off
after 25 minutes in the Ready state.
More About Bluetooth
Bluetooth is a technology that enables Bluetooth-
compliant devices to interconnect easily with each
other using a short wireless connection.
● A Bluetooth device may cause noise or
malfunction, depending on usage, when:
- A part of your body is in contact with the
receiving/transmitting system of the
Bluetooth device or the SoundStand.
- It is subject to electrical variation from
obstructions caused by a wall, corner, or
office partition.
- It is exposed to electrical interference from
same frequency-band devices including
medical equipment, microwave ovens, and
wireless LANs.
● Pair the SoundStand with the Bluetooth device
while they are close together.
● The further the distance between the
SoundStand and Bluetooth device, the worse the
quality is.
If the distance exceeds the Bluetooth operational
range, the connection is lost.
● In poor reception-sensitivity areas, the Bluetooth
connection may not work properly.
● The Bluetooth connection only works when it is
close to the unit. The connection will be
automatically cut off if the Bluetooth device is
out of range. Even within range, the sound
quality may be degraded by obstacles such as
walls or doors.
● This wireless device may cause electric
interference during its operation.