Samsung MX-H630-ZA - Manual (Page 10)

10
English English
10
English
11
Checking or Editing the Programmed
Tracks
You can check a list of programmed tracks and
edit them as you want.
1. If a programmed track is being played, press
the STOP (@) button once.
2. Press the ENTER ( ) button twice to display
the message below:
(C=Check, 01= program number)
➣
If a total of 24 tracks are already pro-
grammed, “C” will be displayed rather
than “P” in the display.
3. Press the ENTER ( ) button repeatedly until
the desired track is displayed.
4. Press the [ or ] button to select a different
track.
5. Press the ENTER ( ) button to confirm your
selection.
6. To play the programmed tracks, press the
PLAY (+) button.
You can play a disc followed by a USB continuously.
1. Press the AUTO CHANGE button.
Each time you press this button, the mode will
switch as follows:
AUTO CHANGE ON ; AUTO CHANGE OFF
• When the auto change mode is "ON", the unit will
play the Disc ; USB continuously.
• When the auto change mode is "ON", if you press
the POWER button, FUNCTION button, or the
OPEN/CLOSE button, the auto change function
automatically switches to "OFF" mode.
• When the USB is playing, if you disconnected
the USB, the auto change function automatically
switches to "OFF" mode.
• When the auto change mode is "ON", the unit
cannot record.
• When the auto change mode is "ON", the REPEAT
and SLEEP functions automatically change to OFF.
• When the auto change mode is "ON", the CD REC
SPEED, USB REC, REPEAT, PROGRAM, DELETE and
SLEEP functions do not work, and the unit displays
"AUTO CHANGE ON".
• When DISC play ends, if there's no USB, the unit
will play the disc.
• When USB play ends, if there's no DISC, the unit
will play music from USB.
Auto Change Function
This function is not available during playback of
an MP3/WMA-CD.
• You can program the playback order of up to 24
tracks of your choice.
• However, you must stop playing the CD before
selecting tracks.
1. While in CD playback mode, press the
STOP(@) button to stop playing the CD.
2. Press the ENTER ( ) button to display the
message below:
(01= program number, --= track number)
3. Use the [ or ] button to move to a desired
track.
• Press [ to move to the previous track.
• Press ] to move to the next track.
4. Press the ENTER ( ) button to confirm
your selection. The selection is stored and
is displayed.
5. To select additional tracks, follow Steps 3
to 4 above.
6. Press the PLAY (+) button to play the
programmed tracks.
7. Press the STOP(@) button to stop playing
the programmed tracks, Press the STOP
(@) button again to cancel playing the
programmed tracks.
• If you open the disc tray or turn off the
product, your programming will be
canceled.
➣
In CD Program mode, if you press the USB
REC or the AUTO CHANGE buttons, these
functions will not work, and the unit will dis-
play "PROG".
10 Skip Function
CD Programming
Press the +10 or -10 button while in playback
mode.
The unit will skip as many as 10 tracks forward
or 10 tracks back from the current track.