Samsung WF431ABW-XAA - Manual (Page 20)

20_ Washing a load of laundry
Override
This is the function that can operate the unit regardless of the DR level.
Setting/Releasing
To turn the Override function on or off, press and hold bo¬th the Temp and Time buttons for 3 seconds.
How to Set:
1. The Override function can be turned on or off when the power is on.
2. The Override function setting is reset when the cycle is complete or the power is turned off.
DR-Ready Operations and Display Method
Operations according to the DR Level
DR Level Operation washer Dryer
DR level 0 N/A Normal operation Normal operation
DR level 1 N/A Normal operation Normal operation
DR level 2
Start Delay: Up to 3 hours
or the user-configured
period of time.
1) Heater is turned off.
2) Normal operation
except for the heater
1) Switches to the pause
state.
DR level 3
1) Switches to the pause
state. 1) Switches to the pause
state.
DR level 4
Power consumption
limitation: Up to 10
minutes. At least 50%
1) Switches to the pause
state. 1) Switches to the pause
state.
Override N/A
Normal operation
regardless of the DR level. Normal operation
regardless of the DR level.
• The Override function can be set to on or off when the power is on (when the button is
pressed and held for 3 seconds).
• The Override function setting is reset when the cycle is complete or the power is turned off.
• The Start/Pause key is ignored when the unit is in a paused DR state.
• If the Override function is activated when the unit is in a paused DR state, the cycle starts.
• The standby time in DR levels 2 and 3 is reset if the state changes to levels 0, 1 or Override.
Display for each DR level
DR Level Display DR Level Display
DR level 0 Cycle time (the same as normal mode.) N/A
DR level 1 L1  Cycle time (the display is toggled at 5 second intervals.)
DR level 2 L2  Cycle time (the display is toggled at 5 second intervals.)
DR level 3 L3  Cycle time (the display is toggled at 5 second intervals.)
DR level 4 L4  Cycle time (the display is toggled at 5 second intervals.)
Override
OR  Cycle time (the display is toggled at 5 second intervals.)
• When the Override function is turned on by pressing the
keys while the power is on.)
• When the power is off or an error has occurred, the DR level is not displayed.
• If the cycle is completed (when ‘End’ is displayed), the DR level is not displayed.
Instantaneous Power Notification Function
If the Gateway requests Instantaneous Power, this function calculates and sends the current
Instantaneous Power.
washing a load of laundry
WF431ABP-03016A-07_EN_v1.indd Sec11:20 WF431ABP-03016A-07_EN_v1.indd Sec11:20 2012-05-09 2:17:25 2012-05-09 2:17:25