American Dryer Corp. ADS-464 - Manual (Page 67)

63
- If yes, adjust the “Time Adjust” until the L.E.D. (light emitting diode) is on during rotation 15 to 20
seconds after the tumbler stops
- If “NO,” check:
- Inductive proximity sensor is located in the same area as the tumbler junction box
- Inductive proximity mechanical adjustment
- The target that is attached to the outside of the basket
- Stop motion detector module
- Circuit wiring; refer to ADS-464 Main Panel Wiring Diagram, ADS-464 Tumbler Junction Box
Wiring Diagram
1b) If the L.E.D. (light emitting diode) is constantly “ON”
- If “YES,” the stop motion detector is defective
- If “NO,” check:
- Inductive proximity sensor for damage. The proximity sensor is located in the same area as the
tumbler junction box.
- Inductive proximity mechanical adjustment
- Tumbler target...this target is attached to the outside of the basket
- Stop motion detector module in the tumbler section on the left front side
- Circuit Wiring; refer to ADS-464 Main Panel Wiring Diagram
- ADS-464 Tumbler Junction Box Wiring Diagram