Samsung HPR5052X-XAP - Manual (Page 16)

16
1 Insert and tighten the Captive Screw in the direction of the arrow.
When done, mount the wall bracket on the wall.
2 Before drilling into the wall, check if the
length between the two locking holes at
the back of the product is correct. If the
length is too short or long, loosen all or
some of the 4 screws on the wall
bracket to adjust the length.
How to assemble the Wall Mount Bracket
3 Check the installation diagram and
mark the drill points on the wall.
Use the 5.0 mm bit to drill holes deeper
than 35 mm. Fix each anchor in the
corresponding hole. Match each of the
brackets and hinge holes to the
corresponding anchor holes and insert
and tighten the 11 screws
.
Captive Screw
Wall Bracket
Hinge (Right)
There are two hinges
(left and right). Use the
correct one.
Hinge (Left)
Length between the
two locking holes
BN68-00835A-00(002~035) 4/6/05 8:19 PM Page 16