Auto Page AutoPage RF-501 - Manual (Page 13)

7. The RF-501 can learn four transmitter codes. If later optional third
and forth transmitters are to be programmed, follow sequence
1 through 6 and re-program ALL existing transmitters.
N. PROGRAMMING THE REMOTE TRANSMITTER FOR SECOND &
THIRD VEHICLES
The RF-501 transmitters are capable of controlling separately
installed RF-501 or RF-30 alarm systems in two or three vehicles.
To code the RF-501 transmitters for two or three vehicles follow the
diagrams as shown. Before multiple vehicle programming can be
achieved, it is necessary to enter the programming mode as
described in SECTION M.
1. TWO VEHICLE OPERATION
VEHICLE #1
Enter the programming mode on VEHICLE #1 and push the GREEN
button on one of the transmitters. The alarm siren will respond with a
confirming chirp. WITHIN FIVE (5) SECONDS, push the BLACK button
on the transmitter for VEHICLE #2. The alarm siren will respond with a
confirming chirp. Both transmitters are now programmed to VEHICLE
#1.
VEHICLE #2
Enter the programming mode on VEHICLE #2 and push the BLACK
button on the first transmitter used for VEHICLE #1. The a larm siren
will respond with a confirming chirp. WITHIN FIVE (5) SECONDS, push
the GREEN button on the second transmitter that had been previously
programmed on VEHICLE #1. The alarm siren will respond with a
confirming chirp. Both transmitters are now programmed to VEHICLE
#2.