Auto Page AutoPage RF-501 - Manual (Page 12)

security feature. If any transmitter is lost or stolen, e nter the
programming mode and re-program existing transmitters.
Transmitters
can only be programmed by entering the programming mode. Existing
codes will remain in memory if power to the RF-501 is disconnected.
To program the RF-501 transmitters, follow the directions as written
below, IN THEIR EXACT ORDER!
1. Flip the VALET/OVERRIDE switch to "ON" position.
2. Turn the ignition switch to "ON", then "OFF", then IMMEDIATELY
3. Flip the VALET/OVERRIDE switch "OFF", "ON/OFF", "ON/OFF". The
siren will chirp one (1) time.
4. Turn the ignition switch "ON/OFF", "ON/OFF". The siren will chirp
two (2) times and the LED STATUS INDICATOR will begin
flashing. You are now in the programming mode.
5. Press the GREEN button on one of the remote transmitters until
the alarm siren responds with a confirming chirp. The first
transmitter is now programmed.
6. WITHIN FIVE (5) SECONDS, press the GREEN button on the
second transmitter until the alarm siren responds with a
confirming chirp. The second transmitter is now programmed.
NOTE: IF THE RF-501 DOES NOT RECEIVE A SECOND CODE
TO LEARN WITHIN FIVE (5) SECONDS IT WILL
AUTOMATICALLY CLOSE THE PROGRAMMING MODE AND
RESUME NORMAL ALARM FUNCTIONS. If this happens, it will
be necessary to repeat steps 1 through 6 and re-program ALL
transmitters.
If three or four transmitters are programmed, continue pressing
the GREEN button of the third and/or fourth transmitters.