Auto Page AutoPage RF-501 - Manual (Page 11)

instantly, and the lights will flash.
2. If optional glass, shock or motion sensors have been installed,
rearm the RF-501 and test according to the directions of the particular
sensor installed.
If triggered in the armed condition, the RF-501 will sound its siren and
flash the lights for 60 seconds; then it will stop and automatically reset
and rearm. If the violation continues, the alarm will sound and lights
will flash for a maximum of two 60 second cycles.
L. IGNITION CONTROL POWER DOOR LOCK SYSTEM
(SELECTABLE)
When equipped with optional relays to control the vehicle power door
locks, the vehicle's doors will automatically lock when the ignition is
switched on. The doors will automatically unlock when the ignition is
switched off. In order to avoid any undesirable lock-out, the doors will
not lock if any door is left open.
If this feature is not desired, move dip switch #4 to "OFF" under the
access door on the RF-501 main unit. Consult your installing dealer
for details.
NOTE: This feature will not work if your vehicle uses a vacuum
operated door locking system.
M. PROGRAMMING THE REMOTE TRANSMITTERS
The RF-501 includes two (2), 2 button mini transmitters which must be
programmed to the alarm BEFORE any alarm function is possible,
and AFTER the RF-501 has been completely installed.
NOTE: EACH TIME THE PROGRAMMING MODE IS ENTERED, ALL
PROGRAMMED TRANSMITTER CODES WILL BE AUTOMATICALLY
DELETED AND MUST BE RE-PROGRAMMED. This is an important