Samsung L83T - Manual (Page 112)

《111》
FAQ
When the movie clip doesn’t play back on the PC
※ When the movie clip recorded by the camera doesn’t play back on the PC,
the causes are mostly due to the codec installed on the PC.
■ When codec for play back the movie clip isn’t installed
→ Install the codec as listed below.
[Installing codec for Windows]
1. Installing the XviD codec
1) Insert the CD provided with the camera.
2) Run the windows explorer and select [CD-ROM drive:\XviD] folder and
click the XviD-1.1.2-01112006.exe file.
※ The XviD codec is distributed according to the GNU General Public License
and everyone can copy, distribute and change this codec. This License
applies to any program or other work which contains a notice placed by the
copyright holder saying it may be distributed under the terms of this General
Public License. For more information, see the License documents
(http://www.gnu.org/copyleft/gpl.html).
[Installing codec for Mac OS]
1) Visit the following site for downloading the codec.
(http://www.divx.com/divx/mac)
2) Click the [Free Download] menu on the top right side of the window then
download windows appears.
3) Check the version of Mac OS and click the [Download] button to download
the file and save it on a desired folder.
4) Run the downloaded file and the codec for playing back the movie clip will
be installed.
※ If the movie file is not played back on the Macintosh OS, use a media
player that supports Xvid codec (e.g: Mplayer).
■ When the DirectX 9.0 or later is not installed
→ Install the DirectX 9.0 or later
1) Insert the CD provided with the camera
2) Run the windows explorer and select the [CD-ROM drive:\ USB
Driver\DirectX 9.0] folder and click the DXESETUP.exe file.
The DirectX will be installed. Visit the following site for downloading the
DirectX.http://www.microsoft.com/directx
■ If a PC (Windows 98SE) stops responding while the camera and PC are
connected repeatedly
→ If a PC (Windows 98SE) is turned on for a long time and the camera is
connected repeatedly, the PC may not recognise the camera.
In this case, re-start the PC.
■ If a PC connected with the camera stops responding while Windows is starting.
→ In this case, disconnect the PC and the camera and Windows will start.
If the problem happens continuously, set the Legacy USB Support to disable
and re-start the PC. The Legacy USB Support is in the BIOS setup menu.
(The BIOS setup menu differs from the PC manufacturers and some BIOS
menus don’t have Legacy USB Support) If you can’t change the menu by
yourself, contact to the PC manufacturer or BIOS manufacturer.
■ If the movie clip can’t be deleted, or the removable disk can’t be extracted or an
error message displays during the file transfer.
→ If you install only the Samsung Master, the problems mentioned above
occasionally happen.
- Close the Digimax Master program by clicking the Samsung Master icon on
the Taskbar.
- Install all the application programs included in the software CD.