Axxess Interface RFASWC - Manual (Page 7)

Remapping the SWC Buttons
Let’s say you have the RFASWC programmed to your radio and you want
to change the button assignment for the steering wheel controls. For
instance you would like Seek Up to be Mute.
NOTES:
• The RFASWC must have detected the radio it is attached to before
you can remap any buttons.
• You can only start the remapping of the steering wheel controls
process within the first 20 seconds of turning the ignition key on. If you
wait longer then the 20 seconds you will have to turn the ignition off
then back on again.
• Within the first 20 seconds if any button other then Volume Up or
Volume Down is pushed, the remapping process will stop.
• If during the remapping process no button is pushed for 30 seconds
the remapping process is aborted and the original settings are reset.
So Let’s Begin The Remapping Process:
1. Ideally having the RFASWC visible is recommended since you can
see the led flashes to confirm button recognition.
2. Turning off the radio is recommended
3. Within the first 20 seconds of turning the ignition on, press and hold
down the Volume Up button for at least 25 seconds.
4. The led will light up solid red. Release Volume Up and the led will go
out. Volume Up has now been programmed.
6