beautypg.com

Axxess Interface RFASWC User Manual

Page 4

background image

2. Turn on the ignition and press volume up on the RFASWC. This will

“marry“ the RFASWC to the interface.

NOTE: If you are replacing a transmitter you must turn on the ignition

and within the first 10 seconds press and hold the source button for ten

seconds. This will “marry the new transmitter.

Programming the RFASWC

1. Complete connections to the vehicle and the aftermarket radio

* If this is the first time the RFASWC is being installed in a vehicle:

2. Turn the ignition on; the led will start flashing rapidly which means the

ASWC is looking for the radio. Go to step 4.

Or

* If the RFASWC was installed in a vehicle before:

2. Turn the ignition on, the led will flash slowly
3. Hold down the reset button for more then 2 seconds but less then 10

seconds, the led will start flashing rapidly
4. After a couple of seconds the led should stop flashing and not light up

for 2 seconds.

3