Connections, Connecting equipment, Preparations rear – Aiwa AV-NW31 User Manual
Page 4: Before connecting the ac cord, Important
4
ENGLISH
CONNECTING EQUIPMENT
Jacks and plugs of the connecting cord are color-coded as follows:
Red jacks and plugs: For the rigtht channel of audio signals
White jacks and plugs: For the left channel of audio signals
Yellow jacks and plugs: For video signals
NOTE
Insert the plugs fully into the jacks. Loose connections may
produce a humming sound or other noise interference.
CONNECTIONS
Before connecting the AC cord
The rated voltage of your unit shown on the rear panel is 120 V
AC. Check that the rated voltage matches your local voltage.
IMPORTANT
Plug in the AC power cord to the AC outlet after all other
connections are made.
*
1
When connecting a monaural video, use a stereo-mono
connecting cord (not supplied).
*
2
When connecting an LD player equipped with the
AC-3 RF OUT
terminal, use an RF demodulator unit.
Also connect the analog
AUDIO OUT terminals of the LD player to the receiver to play
all the sources. For further information, refer to the instructions
of the LD player .
PREPARATIONS
REAR
COAXIAL
(VIDEO 2)
OPTICAL
(VIDEO 1)
OPTICAL
(DVD)
DIGITAL IN
PCM
/ DOLBY DIGITAL
/ DTS
VIDEO
DVD
VIDEO 1 / MD
VIDEO 1 / MD
TAPE
AUX
CD
MONITOR
VIDEO 2
/ LD / TV
VIDEO 2
/ LD / TV
IN
IN
IN
IN
IN
IN
OUT
VIDEO OUT
OUT
IN
IN
IN
OUT
DVD
AUDIO
L
R
*
3
Input sound through the DIGIT AL IN terminals (COAXIAL
(VIDEO 2), OPTICAL (VIDEO 1) and OPTICAL (DVD)) cannot
be recorded. When recording the sound from the DVD, CD, MD
or LD player , connect the analog AUDIO OUT terminals of the
player to the corresponding
AUDIO IN terminals of the receiver .
*
4
With this connection, the picture noise may appear when playing
copy protected DVDs. In this case, it is recommended to connect
the VIDEO OUT terminal of the DVD player directly to a
TV set,
not through the receiver .
TV
DVD, video 2*
1
, LD*
2
or cable TV
Optical connecting cord
Video 1*
1
or MD player
to VIDEO OUT*
4
to AUDIO OUT
to COAXIAL
DIGITAL OUT
Coaxial
connecting cord
*
3
*
3
*
3
Optical
connecting cord
to VIDEO OUT*
4
to AUDIO OUT
to LINE IN
to LINE OUT
Tape deck
DVD player
CD player
to LINE OUT
to AUDIO OUT
to VIDEO IN
to AUDIO IN
to VIDEO IN (V ideo 1)
to AUDIO OUT
to VIDEO OUT (Video 1)
u
Signal stream
to OPTICAL
DIGITAL OUT
to OPTICAL DIGITAL OUT