AMX Mio Modero R-3 - Manual (Page 22)

Programming The Mio R-3
18 Mio Modero R-3 Remote
Serial Commands (Cont.)
^TXT
Assign a text string to those
buttons with a defined
address range
Sets non-unicode text.
Syntax:
SEND_COMMAND ,"'^TXT-,'"
Variables:
• variable text address range = 1.
• button states range = 1 - 256 for multi-state buttons 
(0 = All states, for General buttons 1 = Off state and 2 = On state).
• new text = 1 - 50 ASCII characters.
Example:
SEND_COMMAND Keypad,"'^TXT-1,Test Only'"
Sends text to variable text line on display.
Note: You must send an ^FML command before sending variable text to an R3
remote.
^UNI
Set Unicode text
For the ^UNI command (%UN and ^BMF command), the Unicode text is sent
as ASCII-HEX nibbles.
Syntax:
SEND_COMMAND ,"'^UNI-,range>,'"Variables: • variable text address range = 1.• button states range = (0 = All states, for General buttons 1 = Off state and 2 = On state). • unicode text = Unicode HEX value. Example:To send the variable text 'A' in Unicode to all states of the variable text display,
(for which the character code is 0041 Hex), send the following command:SEND_COMMAND Keypad,"'^UNI-1,0,0041'"Note: Unicode is always represented in a HEX value.ZAP! Erase Configuration Information in Flash MemorySyntax:ZAP! tVariables:• t = MENU or FONT or blankExample:ZAP!Clears all configuration information and erases the font. The text displayed on
the LCD for the six devices returns to default and all parameters that can be set
in Setup Mode are reset to their default value.ZAP! MENUSets the text displayed on the LCD for the six devices to the default values.ZAP! FONTErases the font from the flash.Note: These commands are intended for serial use only. These commands
cannot be issued when the device’s Setup Page is open.ZIGCSets the ZigBee ChannelSyntax:ZIGC (Decimal)Example:ZIGC 26ZIGPSets the ZigBee Extended
PAN IDSyntax:ZIGP (Decimal)Example:ZIGP 123A
range>,'"
Variables:
• variable text address range = 1.
• button states range = (0 = All states, for General buttons 1 = Off state and

2 = On state).
• unicode text = Unicode HEX value.
Example:
To send the variable text 'A' in Unicode to all states of the variable text display,
(for which the character code is 0041 Hex), send the following command:
SEND_COMMAND Keypad,"'^UNI-1,0,0041'"
Note: Unicode is always represented in a HEX value.
ZAP!
Erase Configuration

Information in Flash Memory
Syntax:
ZAP! t
Variables:
• t = MENU or FONT or blank
Example:
ZAP!
Clears all configuration information and erases the font. The text displayed on
the LCD for the six devices returns to default and all parameters that can be set
in Setup Mode are reset to their default value.
ZAP! MENU
Sets the text displayed on the LCD for the six devices to the default values.
ZAP! FONT
Erases the font from the flash.
Note: These commands are intended for serial use only. These commands
cannot be issued when the device’s Setup Page is open.
ZIGC
Sets the ZigBee Channel
Syntax:
ZIGC (Decimal)
Example:
ZIGC 26
ZIGP
Sets the ZigBee Extended
PAN ID
Syntax:
ZIGP (Decimal)
Example:
ZIGP 123A