AMX Mio Modero R-3 - Manual (Page 21)

Programming The Mio R-3
17 Mio Modero R-3 Remote
Serial Commands (Cont.)
SETD
Sets the ICSP Device

Number
Syntax:
SETD
Example:
SETD 10020
Note: ICSP Device number cannot be set above 32000.
^SHO
Show or hide text with a set
variable text range
Syntax:
"'^SHO-,'"
Variables:
• variable text address range = 1 - 6; the address range corresponds to the
dynamic line number.
• command value = (0= hide, 1= show).
Example:
SEND_COMMAND Panel,"'^SHO-1,0'"
Hides text on dynamic line 1 of the LCD button.
SLEEP-#
Set the Sleep timer or put the
remote to sleep immediately.
This command can be used if a sleep time other than 3, 6, 9, or 12 seconds is
desired.
Syntax:
"'SLEEP-#'" (timed sleep; a persistent command)
Variables:
• # = 0 - 60 in seconds; time to wait before going to sleep. Default is 30. 0 sets
the device to never sleep.
Example:
SEND_COMMAND Panel,"'SLEEP-45'"
Sets the sleep timer to 45 seconds. After 45 seconds of inactivity, the remote
will go to sleep.
SEND_COMMAND panel,"'SLEEP'"
Force the keypad to go to sleep.
@SSL
Sends a string to the master
upon going to sleep
Syntax:
"'@SSL-'"
Variables:
• new text = 1 - 20 ASCII characters. Default string is SLEEP.
Example:
SEND_COMMAND Panel,"'@SSL-KeyPad Sleep'"
Sends the string " KeyPad Sleep'" to the master at time of sleep.
@SST
Sends a string to the master
upon startup
Syntax:
"'@SST-'"
Variables:
• new text = 1 - 20 ASCII characters. Default string is STARTUP.
Example:
SEND_COMMANDPanel,"'@SST-Panel Start'"
Sends the string " Panel Start " to the master at time of start up.
@SWK
Sends a string to the master
upon wake up
Syntax:
"'@SWK-'"
Variables:
• new text = 1 - 20 ASCII characters. Default string is WAKEUP.
Example:
SEND_COMMAND Panel,"'@SWK-Wake KeyPad"
Sends the string " Wake KeyPad " to the master at time of wake up.