AMX Mio Modero R-3 - Manual (Page 18)

Programming The Mio R-3
14 Mio Modero R-3 Remote
Serial Commands
The Mio R-3 remote supports a few commands that can be uploaded to the device using a terminal program
such as HyperTerminal. These commands are not needed for normal usage or programming of the remote.
Channel Codes (Cont.)
Button Dev 1 Dev 2 Dev 3 Dev 4 Dev 5 Dev 6
INFO 39 79 119 159 199 239
LAST 40 80 120 160 200 240
TV (Device 1) 241 241 241 241 241 241
SAT (Device 2) 242 242 242 242 242 242
DVD (Device 3) 243 243 243 243 243 243
CD (Device 4) 244 244 244 244 244 244
AUX (Device 5) 245 245 245 245 245 245
LGHT (Device 6) 246 246 246 246 246 246
A (Macro 1) 250 250 250 250 250 250
B (Macro 2) 251 251 251 251 251 251
C (Macro 3) 252 252 252 252 252 252
Serial Commands
@BRT
Set Brightness level
This command can be used to customize the brightness of the red LEDs that
backlight the power button if the predefined brightnesses in Setup Mode are
not fine enough.
Syntax:
"'BRIT-,
level>'"
Variables:
brightness level # = a value from 0 - 32.
"'@BRT-#'" (Set LED Awake brightness level)
"'@BRT-#,#'" (Set LED Awake brightness level, sleep brightness level)
Example:
(1) "'@BRT-16'"
Sets the awake brightness level to 50%.
^CFG #
Enable or Disable Debug
Mode
Syntax:
^CFG-
Variables:
• # = (1 = Debug Mode ON, 0 = Debug Mode OFF).
Example:
^CFG-1
Turn Debug Mode ON