Campbell Scientific RavenXTV CDMA Sierra Wireless Cellular Modem - Manual (Page 16)

RavenXTV CDMA Sierra Wireless Cellular Modem
Indicator Lights
When your RavenXTV is connected to power and an antenna, there is a
specific pattern to the lights to indicate its operation mode.
• Network—Indicates a successful connection to the cellular network with
an IP address given and a channel acquired.
• Signal—Light shows the strength of the signal and may be nearly solid
(strong signal) or flashing (weaker signal). A slow flash indicates a very
weak signal.
• Activity—Lights will flash as data is transferred to and from the PinPoint
modem on the remote network.
• Power—Indicates the power adapter is connected and there is power
getting to the RavenXTV.
• The Reset button (on the left side of the RavenXTV) has two functions.
If it is quickly depressed and released, the modem will simply power cycle
the internal hardware. If, however, the reset is depressed and held for
several seconds (count to 10 slowly and wait for the power light to go off
after the light pattern stops), the ALEOS configuration settings will return
to the factory defaults.
Light Patterns
The LEDs on the front of the modem will respond in different patterns to
indicate modem states.
• Normal—Each LED, mentioned above, lit as applicable.
• Start up—The LEDs will cycle from left to right.
• PassThru Mode—Network and Signal LEDs will blink in tandem. The
Activity LED will blink when transmitting or receiving data.
• SOS—The Network LED blinks.
• Configuration Reset—The LEDs will cycle left to right and then right to
left 4 times.
10