Campbell Scientific CM106BK Tripod Kit - Manual (Page 20)

CM106BK Tripod Kit
2.7 Crossarm Attachment
Attach the CM202 (0.6 m, 2 ft), CM204 (1.2 m, 4 ft), or CM206 (1.8 m, 6 ft)
crossarm to the tripod mast as shown in FIGURE 2-8. For wind sensors, the
crossarm should be approximately 103 inches above the ground. Typically the
crossarm is oriented East/West for wind sensors, North/South for
pyranometers.
FIGURE 2-8. CM204 Crossarm
2.8 Enclosure Attachment
The ENC10/12, ENC12/14, ENC14/16, and ENC16/18 enclosures can be
ordered with mounting brackets for the CM106BK tripod. All enclosure
models can be mounted to the tripod mast (above the legs) with the –MM Mast
Mount bracket option. All enclosure models except the ENC16/18 can be
mounted to the tripod base and leg with the –LM Leg Mount bracket option.
2.8.1 Enclosure Mounting to Tripod Mast
An enclosure ordered with the –MM bracket has a three-piece top and bottom
brackets with a U-bolt for each bracket.
Attach an enclosure with the –MM mounting bracket to the tripod mast as
follows:
Remove the U-bolts washers and nuts from the brackets.
Position the enclosure against the tripod’s mast (North side recommended).
Install the U-bolts, flat washers, lock washers, and nuts. Tighten the nuts until
the lock washers are compressed.
CM200 Series
Crossarm
Tripod Mast
12