Campbell Scientific BMP5 Direct SDK - Manual (Page 28)

Appendix A. Sample Program Table Structure
WeatherHawk Weather Station Tables
The following tables show the table structure from a default WeatherHawk
weather station program installed in a CR200 datalogger. When
communicating with a datalogger using the BMP5 Direct SDK, knowing the
table structure of the running program is necessary for some commands
Table Number 1 – Status
Field Number Field Name Units Notes:
Field 1 OSVersion Operating System Version
Field 2 OSDate Date of Operating System
Field 3 ProgName The name of the program running in the datalogger
Field 4 ProgSig The signature of the running program
Field 5 CalOffset
Field 6 PakBusAddress The PakBus address of the datalogger (1-4094)
Field 7 RfInstalled Radio Detected
Field 8 RfNetAddr Valid Addresses are 0-63
Field 9 RfAddress Valid Addresses are 0-1023
Field 10 RfHopSeq Valid numbers are 0-6
Field 11 RfPwrMode RF1_Sec
Field 12 Rf_ForceOn
Field 13 RfSignalLevel RF signal strength should be above 40
Field 14 RfRxPakBusCnt
Field 15 VarOutOfBounds
Field 16 SkipScan Program didn’t complete before the next execution interval
Field 17 TrapCode
Field 18 WatchDogCnt Number of Watchdog Errors
Field 19 ResetTables Clears All Stored Data
Field 20 BattVoltage Volts Current Battery Voltage
A-4