LBL Lighting Standoff Ball Joint Assembly User Manual
Telescoping rigid standoffs with ball joint, Installing the standoff

Installation Instructions for
Telescoping Rigid Standoffs with Ball Joint
1.0
HANGER-ADJ-_-2-BJ
980MR2VTSP
1
Installing the Standoff
ANCHOR
Select a location on the sloped ceiling where the Monorail is to
be mounted.
One way of marking the standoff locations on the ceiling is to
lay the Monorail on the floor underneath of the selected
location and by using a plumb bob pointing on the center of
the Monorail mark the points on the sloped ceiling.
The other way is to hold the Monorail directly against the
sloped ceiling and mark the standoff points on the ceiling.
Tap the anchors at the marked points up to the threaded
portion with a hammer.
Screw the anchors in the rest of the way with a Phillips
screwdriver.
Insert the #8 screw into the threaded nipple and washer.
Tighten the #8 screw completely into the anchor to secure the
washer and threaded nipple in place.
Repeat steps 4 through 6 for the remaining standoffs.
CEILING
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is suitable for indoor dry locations only.
This product must be used with LBL Monorail system only.
This instruction is for the following models:
Monorail Support 2.5" - 4" (HANGER-ADJ-_1-2-BJ)
Monorail Support 6" - 10" (HANGER-ADJ-_2-2-BJ)
Monorail Support 12" - 24" (HANGER-ADJ-_3-2-BJ)
Monorail Support 24" - 48" (HANGER-ADJ-_4-2-BJ)
Monorail Support 48" - 96" (HANGER-ADJ-_5-2-BJ)
#8 SCREW
THREADED NIPPLE
WASHER
2-Circuit Monorail
1B
1A
1
2
3
4
6
5
4
6
1B
1A
5
7
1B
1C